CPA6-LD is the fifth generation CPA brackish water RO membrane and has the best rejection of all of its predecessors at 99.8%. This 400 sq. ft. membrane operates at a higher feed pressure than CPA5-LD but it has the highest rejection in the CPA family.
CPA6-LD membranes are designed with Low Differential Pressure LDTM Technology designed to minimize colloidal fouling. They have 37.0 m2 (400 ft2) membrane area. Using CPA6-LD results in cost saving while still getting a high rejection from membranes.
CPA6-MAX has the same high rejection membrane of CPA6-LD, but features a 10% increase in membrane area at 440 sq.ft. CPA6 MAX is a preferred choice for feed waters of low turbidity and silt density index such as brackish well waters.
CPA6-LD and CPA6-MAX membranes are available in diameters of 8.0 inches only.
- Permeate Flow: 8,800 gpd (33.3 m3/d)
- Salt Rejection: 99.75 % (99.6% minimum)
- Type Configuration: Spiral Wound
- Membrane Polymer: Composite Polyamide
- Nominal Membrane Area: 440 ft2 (40.9 m2)
The stated performance is initial (data taken after 30 minutes of operation), based on the following conditions:
- 1,500 ppm NaCl
- 225 psi (1.55 MPa) Applied Pressure
- 77 °F (25 °C) Operating Temperature
- 15% Permeate Recovery
- 6.5 - 7.0 pH Range
Standard Operating Limits:
- Maximum Applied Pressure: 600 psig (4.14 MPa)
- Maximum Chlorine Concentration: < 0.1 PPM
- Maximum Operating Temperature: 113 °F (45 °C)
- pH Range, Continuous (Cleaning): 2-11 (1-13)
- Maximum Feedwater Turbidity: 1.0 NTU
- Maximum Feedwater SDI (15 mins): 5.0
- Maximum Feed Flow: 75 GPM (17.0 m3/h)
- Minimum Ratio of Concentrate to
- Permeate Flow for any Element: 5:1
- Maximum Pressure Drop for Each Element: 15 psi
Ideal Applications Include:
- Desalting of Well Waters – Municipal Drinking Water
- Reducing TDS Prior to Ion Exchange
- Boiler Make-Up Water
- Ultrapure Water for Semi-Conductor Manufacture